Custom Engineering s'print - Cleaning the rubber roll

1. INSTALLATION AND USE
121-
DPT100-B/I/BT
Alcohol, solvent
(Fig.1.18)
1.6.4 Cleaning the rubber roll
To clean the rubber roll proceed as follows:
• Turn the printer off briefly pressing the multifunction key, located on the front, two times.
• Lift the paper compartment cover.
• Clean the rubber roll using a medium-stiff brush to avoid them being scratched (see fig. 1.18).
• Do not use alcohol or solvents.
• Do not let water or other liquids get inside the machine.