Custom Engineering s'print - Page 40

3. PRINTER FUNCTIONS
3-6
DPT100-B/I/BT
• After the command execution the printer ignores all the characters received from the
communication port until to the next $1B $02 reception.
• After receiving this command the infrared led is functioning, as usual.
[Default]
[Reference] $1B $02
[Example]
n32$B1$
[Name] Transmit printer ID
[Format] ASCII ESC # n
Hex 1B 23 n
Decimal 27 73 n
[Range] 1 ≤ n ≤ 3, 49 ≤ n ≤ 51
[Description] Transmits the printer ID specified by n follows:
nDIretnirPnoitacificepS
94,1DIledomretnirP
)loc42(05$
)loc04(45$
loc42(06$ htooteulB )noisrevygolonhcetsseleriw
loc04(16$ htooteulB )noisrevygolonhcetsseleriw
05,2desutoN00$nodexiF
15,3MORDInoisrevsdnepeDno)rahc4(MORnoisrev
[Notes] • This command is executed when the data is processed in the data buffer. Therefore,
there could be a time lag between command reception and data transmission, depending
on data buffer status.
[Default]
[Reference]
[Example]
03$B1$
[Name] Turning the printer off
[Format] ASCII ESC 0
Hex 1B 30
Decimal 27 48
[Description] Turning the printer off.
[Notes]
[Default]
[Reference]
[Example]
04$B1$
[Name] Resets the printer
[Format] ASCII ESC @
Hex 1B 40
Decimal 27 64
[Description] Cancels all the data in the print buffer and resets the printer mode, restoring the mode