3. PRINTER FUNCTIONS
3-7
DPT100-B/I/BT
which was enabled at the moment of switching on
[Notes] • Same as hardware reset
• After the command has been transmitted, 1.5 seconds elapse before the printer is
enabled
[Default]
[Reference]
[Example] This can be useful during switching on in order to avoid the sending of false characters
during initialization by the master device.
]Ln[]Hn[14$B1$
[Name] Executes [n] dots line feed
[Format] ASCII ESC A nH nL
Hex 1B 41 nH nL
Decimal 27 65 nH nL
[Description] Executes [n] dots line feed.
[Notes]
[Default]
[Reference]
[Example]
nd...0dnm24$B1$
[Name] Sets and reads the communication BlueTooth parameters
[Format] ASCII ESC B m n d0... dn
Hex 1B 42 m n d0... dn
Decimale 27 66 m n d0... dn
[Range] 1 ≤ m ≤ 8
0 ≤ d0, dn ≤ 255
[Description] Sets and reads the parameters for BlueTooth communication ; m indicates wich
operation is selected as specified below :
mn noitarepO
161-1ehtsetirW emaNTB eulavretemarap
28-1ehtsetirW NIPTB eulavretemarap
3
1
ehtsetirW noitacitnehtuA eulavretemarap
4ehtsetirW eliforPhsuPtcejbO eulavretemarap
5
0
ehtsdaeR emaNTB eulavretemarap
6ehtsdaeR NIPTB eulavretemarap
7ehtsdaeR noitacitnehtuA eulavretemarap
8ehtsdaeR eliforPhsuPtcejbO eulavretemarap
• n specifies the lenght of the byte to receive and it’s depends by m value;
• d0...dn specifies the byte to store;
[Notes] • if 1 ≤ m ≤ 8 the $06 character (ACK) is returned; otherwise the $15 character (NACK) is
returned.
• It’s recommended to entered the PINs parameter value as decimal digits because some
To Next Page
Loading...
