3.PROG/SET：FUNC switch:
In display mode，PROG/SET key and screen shows Cd00
(General parameter input area).，Press PROG key again
and screen shows CE-00 (failure and engineering mode). If
pressed PROG key now, screen would return to display
mode.
SAVE function: In parameter input mode, press PROG/SET key will save
new parameter just input.
4.READ：READ function：When display shows Cd-?? (General parameter Input mode) or
CE-?? (Failure display and engineering mode), Press
READ to parameter input mode. Screen showing
previously parameter setting. Change of parameter can be
proceeding.
Back to display function：Press READ at parameter input mode can escape
from parameter input mode and not save new parameter.
5.
Key (＜ as shown): SHIFT function：press ＜ key to swich position of nonius，
when the nonius is at left，press ＜key nonius will be back to
right，when accommodate to press ▼、▲key to modify
parameter in this mode.
6.▼、▲ key:
Item of display changing：Press▲, ▼ key at display mode, select required
item.
Parameter selection：Press ▲,▼ key to change value when screen
shows Cd- (General parameter input area) or CE-
(Failure display and engineering mode). Press and
hold ▲,▼ key can progressively increase or
decrease value.
Parameter modification：Press ▲,▼ key at parameter input mode can
change parameter. Using with SET key to
modify parameter.
To Next Page
