CWT 5016 - Internal Sensor Setup

23
SHEN ZHEN YIKEHUDONG
TECHNOLOGY TRADE LT
D
TEL
：
+86
-
755
-
26719954
4.6
Setup I
-
sensors
4.6.1
Buzzer
Attention
:
This
setting is
valid
for the RTU
models that have
buzzer.
The buzzer
can be activated when alarm.
I
n this page,
you
ca
n e
n
able or disable the buzzer and set
interval time of alarm
4.6.2
Tmp100 sensor
(optional)
Attention
:
This
setting is
valid
for the RTU
models that are
added interior temperature sensor, the
tmp100 temperature is optional,
a standard
RTU
have not internal
temperature sensor
.
CWT501
6
Use
r
’s manual
24
www.mobq2000.com
You
can preset a high and a low temperature value, if temperature is over normal range, RTU alarm. You
also can send sms command to RTU to get current temperature.
User can set
“
Adjust
”
value to
calibrating
temperature value

T
imespan
of
twice alarm sms
It is
designed
to avoid amounts of alarm/recover sms in a short time.

TMPRS time:
timespan of
resend alarm sms
It is d
esigned for repeat alarm status notifies
to phones, 0 means disable repeat notification.

time of ensure alarm
It i
s
a
counter of alarm status ensure timer, designed to avoid shake mistakes. 0 means no counter.
4.6.3
Internal battery
(optional)
Attention
:
This
setting is
valid
for the RTU
models that are
internal battery.
It
is
designed to
realize
power lost alarm
When
external power cut off, RTU
P
owered by internal battery and alarm to cs numbers

time of ensure power alarm
When the time of external power lost is over the time, RTU alarm,
“
0
”
means
disabl
e the function.
Battery parameter:

Lithium
battery

Voltage:
3.7
V

Capacity:
80
0mAh

Limited voltage for charging
4.2V

Implementation standard
GB/T 18287
-
2000