EasyManuals Logo
Home>CYBEX gold>Car Seat>CLOUD G

CYBEX gold CLOUD G User Manual

CYBEX gold CLOUD G
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #74 background imageLoading...
Page #74 background image
74
Using the Infant Carrier on Aircraft
4. Check the recline angle. Adjust the seat
angle UNTIL THE BLUE LEVEL LINE
ON THE INFANT CARRIER IS LEVEL
WITH THE FLOOR OF THE AIRCRAFT.
NOTE: A tightly rolled airline blanket may
be placed under the Infant Carrier, near
the vehicle seat back, (as indicated by the
green circle) to adjust the angle .
5. Grab the Infant Carrier at the Belt Guides
and pull from side to side and front to
back to make sure it is installed correctly.
The Infant Carrier should not move more
than 2.5 cm (1 in) in any direction.
If the Infant Carrier moves too much,
tighten the airplane belts more and
recheck.
6. If using a CLOUD G LUX and your seat
is equipped with SensorSafe, unfasten
the chest clip. In order to comply with the
FAA regulation for Portable Electronic
Devices (PED), the SensorSafe Chest
Clip MUST be unfastened during take-off
or landing.
NOTE: After landing, refasten the
SensorSafe Chest Clip before removing
the Infant Car Seat from the Aircraft seat.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CYBEX gold CLOUD G and is the answer not in the manual?

CYBEX gold CLOUD G Specifications

General IconGeneral
BrandCYBEX gold
ModelCLOUD G
CategoryCar Seat
LanguageEnglish

Related product manuals