38
Installing and Removing the Infant Carrier
Installing with Base Using Rigid LATCH (Recommended Method)
1. Ensure Rigid LATCH is removed from
storage and positioned for use (see pg.
28).
2. If equipped, unfold the Load Leg from
underneath the Base.
NOTE: If necessary, the Base may
be installed with the Load Leg folded
up underneath the Base. Consult the
vehicle owner's manual and the Load
Leg Warnings on pages 21-22 of this
manual. If ALL installation requirements
for the Load Leg cannot be met, you
MUST choose another seating position
or install the Infant Carrier without the
Base.
3. Position Base on a rear vehicle seat.
4. Press the two buttons on both sides of
the Rigid LATCH and fully extend the
LATCH/UAS Connectors.
Front of vehicle
qq
ww
ee
rr
To Next Page
Loading...
Need help?
General
