CYBEX gold SIRONA S User Manual

50
To ensure a better fit for smaller infants, the Newborn Insert may be
needed. ONLY USE the Newborn Insert that comes with your original
car seat or one that has been specifically designed for it by CYBEX.
To Install:
1. Pull Harness Buckle through slot in the bottom of Newborn Insert.
2. Pull both Harness Straps over the side panels of Newborn Insert.
3. Push Newborn Insert firmly into Child Restraint to make sure it is
properly positioned.
4. When positioning the Headrest make sure the bottom of the
Headrest flap is behind the Newborn Insert flap.
CHILD RESTRAINT FEATURES
NEWBORN INSERT
CHILD RESTRAINT FEATURES
NEWBORN HEADPAD INSERT
To ensure a better fit for smaller infants, the Newborn Headpad Insert
may be needed. ONLY USE the Newborn Headpad Insert that comes
with your original car seat or one that has been specifically designed for
it by CYBEX.
To install, tuck the tabs on the rear of the Newborn Headpad Insert into
the slots on the Headrest cover and toward the center of the Headrest.

CYBEX gold SIRONA S Specifications

General

Category	Convertible Car Seat
Height Limit	Up to 49 inches
Rotation	360-degree rotation
Harness Type	5-point harness
Child Height	Up to 49 inches
Direction	Rear-facing and Forward-facing
Installation	LATCH system
Safety Features	Energy-absorbing shell
Fabric	Machine washable cover
Standard	FMVSS 213
Headrest	Adjustable headrest
Child Age	Birth to 4 years approximately
Additional Features	Magnetic belt holders, Load leg base