EasyManuals Logo

CYBEX gold SIRONA S User Manual

CYBEX gold SIRONA S
246 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
53
English
INSTALLING CHILD RESTRAINT WITH LATCH
BEFORE installing Restraint, make sure vehicle is on level ground. Place Restraint on approved
LATCH vehicle seating location.
REAR-FACING: DO NOT install by this method for a child weighing more than 13.6 kg (30 lbs).
ALWAYS store Tether Strap when using REARFACING.
FORWARD-FACING: DO NOT install by this method for a child weighing more than 15.9 kg (35
lbs).
ALWAYS USE A TETHER FORWARD-FACING if a Tether Anchor is available.
1. Remove LATCH Anchors from storage
locations on back side of base. Remove each
Connector by pulling out on Red Strap.
2. Unfold Load Leg from underneath Base.
1
2
1
2
34

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CYBEX gold SIRONA S and is the answer not in the manual?

CYBEX gold SIRONA S Specifications

General IconGeneral
CategoryConvertible Car Seat
Height LimitUp to 49 inches
Rotation360-degree rotation
Harness Type5-point harness
Child HeightUp to 49 inches
DirectionRear-facing and Forward-facing
InstallationLATCH system
Safety FeaturesEnergy-absorbing shell
FabricMachine washable cover
StandardFMVSS 213
HeadrestAdjustable headrest
Child AgeBirth to 4 years approximately
Additional FeaturesMagnetic belt holders, Load leg base

Related product manuals