108
CARE AND CLEANING
3
3. Attach Harness Straps to Splitter Plate.
NOTE: Make sure straps are not twisted
and fully attached to the Splitter Plate as
shown to prevent detachment.
4. Attach Harness Strap to Seat Pan.
a. Attach Harness Strap to hip anchor.
b. Slide hip anchor pin
a
outward to
lock and repeat at other side.
NOTE: Make sure straps are not twisted
and fully attached to the Seat Pan as
shown.
5. Secure the two snaps on the Back
Padding to the Seat Cover.
6. Reinsert the Harness Straps through the
loops connecting the Headrest Cover to
the seat and close the two snaps.
4
a
To Next Page
Loading...
