Cybex Platinum CLOUD T - No Rethread Harness

37
The CLOUD T has a Headrest that automatically adjusts the Harness height without
the need to undo and rethread the Harness. Using the seat's No Rethread Harness, the
Headrest may be adjusted up and down through 12 positions to t your child.
1. Unbuckle the Harness and Chest Clip, then drape the Harness over the sides of the
Infant Car Seat Shell.
2. Place the child in the Infant Car Seat, making sure their back and bottom are ush with
the Car Seat and the Buckle Strap is snug against the child but NOT under the child's
bottom.
3. Adjust for your child by pulling up on the No
Rethread Harness Adjuster
A
while sliding
the Headrest up.
IMPORTANT For proper use of the Infant
Car Seat, the Harness Straps MUST be AT
OR JUST BELOW the tops of your child's
shoulders (pg. 8).
4. Buckle and tighten Harness.
NOTE: Regularly check for proper Harness
height as your child grows.
Product Features and Descriptions
No Rethread Harness
A