Cybex Platinum CLOUD T - Installing Without Base Using Lap Belt Only

61
Installing and Removing the Infant Car Seat
Installing without Base Using Lap Belt Only
• ALWAYS have the handle LOCKED while using this Child Restraint in a
vehicle.
• NEVER recline back rest when using carrier in vehicle.
1. Make sure the vehicle is on level ground and position the
Infant Car Seat rmly against the back of the rear vehicle
seat.
q
w
!
WARNING! DEATH or SERIOUS INJURY can occur.
2. Route the vehicle LAP BELT through the CARRIER-
ONLY BELT PATH and BUCKLE THE BELT.
3. Push Infant Car Seat rmly into vehicle seat, pressing
down near the Buckle Strap between the child’s legs,
while removing slack from the LAP BELT.
If necessary, tuck the loose end of the LAP BELT out of
the way.