73
Securing the Child
10. To test for a properly tightened Harness,
pinch a Shoulder Strap. A snug Harness
should not allow you to pinch any slack
when pinched between your thumb and
forenger. If needed, pull Adjuster Strap
further for a tight and proper t.
NOTE: If there is still a gap between
the child and the Harness Buckle, place
a tightly rolled washcloth between the
child and the Buckle to prevent the child
from sliding down or slouching.
11. Recheck the recline angle with the
child secured in place.
• If installed with the base, check
that the Recline Angle remains in the
blue zone on the Recline Indicator.
• If installed without the base,
ensure that the BLUE LEVEL LINE
on the shell is level with the ground.
a
To Next Page
Loading...
