Facility Safety Precautions
• Make sure all user and safety precautions are observed.
• Read and understand the Owner’s Manual completely before using the unit.
• Make sure all users are properly trained on how to use the equipment.
• Make sure that each machine is setup and operated on a solid level surface. Do not install
equipment on an uneven surface.
• Make sure there is enough room for safe access and operation of the equipment.
• Perform regular maintenance checks on the equipment. Also pay close attention to all areas most
susceptible to wear, including (but not limited to) cables, pulleys, belts and grips.
• Immediately replace worn or damaged components. If unable to immediately replace worn or
damaged components then remove from service until the repair is made.
• Do not attempt repairs, electrical or mechanical. Seek qualified repair personnel when servicing. If
you live in the USA, contact Cybex Customer Service at 888-462-9239. If you live outside the USA,
contact Cybex Customer Service at 508-533-4300.
• Disconnect the optional power adapter before servicing the unit.
• Keep a repair log of all maintenance activities.
• Use only Cybex supplied components to maintain/repair the equipment.
• Do not use attachments unless recommended for the unit by Cybex.
• Do not use the unit if: the unit is plugged into an optional power adapter that has a damaged
cord; (2) the unit is not working properly or (3) if the unit has been dropped or damaged. Seek
service from a qualified technician.
• Do not use the optional power adapter in damp or wet locations.
• EQUIPMENT not suitable for use in the presence of a FLAMMABLE ANAESTHETIC MIXTURE WITH
AIR or WITH OXYGEN OR NITROUS OXIDE.
• Do not use the unit outdoors.
• The 630A may generate electromagnetic or other forms of interference, or it may be affected by
interference from other equipment nearby. If this is suspected, take precautions by separating the
equipment or otherwise shielding it to avoid such interference.
NOTE: It is the sole responsibility of the user/owner or facility operator to ensure that regular
maintenance is performed.
Arc Trainers containing the A/V options
• Devices connected to Cybex equipment must comply with appropriate safety standards. This
includes but not limited to: (UL-60601, IEC/EN 60601-1) for medical equipment.
• There must be adequate mechanical mounting of the device in all combinations
(configurations).
Cybex Arc Trainer 630A Owner’s Manual
Safety
Page 1-3
To Next Page
Loading...
Need help?
General
