Cybex Arc Trainer 750A/750AT Owner’s Manual
45
Custom Programs
A maximum of nine custom programs can be created from any workout session. The unit
automatically records incline and resistance; anticipating storing the workout as a custom program
when completed.
Enable the SAVE function by rst entering Setup mode. To enter Setup mode, key sequence
CLEAR, 7-5-0, ENTER during the initial Count Down mode. Pressing the CLEAR key will halt the
countdown to help facilitate keying in 7-5-0, ENTER in sufcient time.
From the menu, use +/- keys to navigate to menu item SAVE PROGRAM and press ENTER to allow
editing the feature.
NOTE: If unit is equipped with an optional power supply, Set Up mode can also be entered during the
Dormant mode.
See Assembly and Set Up for more information on Set Up mode.
To save custom program
During 1. Review Mode, press the SAVE key within the rst ve seconds. The text area will display
“SAVE AS PROG 0X”. X represents the next available slot (01-09).
Using the keypad, enter a number (01 to 09). The 2. +/- keys are available to scroll through the nine
custom program slots.
Press 3. ENTER key to accept and store program.
If nine custom programs already exist, no slots are available; the text area will display “REPLACE
PROG 0X name.” The 0X represents the rst custom program in the list. Use the keypad or LEVEL
keys as described above to select program number.
To play back custom program
Press the Programs key and use the key pad to key in 01 – 09, then press ENTER key.
Note that these programs do not prompt the entry of level or time, as these are aspects that were
saved as part of the program itself.
To delete a custom program
Custom programs require a minimum of one minute, anything less than one minute effectively erases
the program location.
Start a workout session (such as Quick Start) and end before one minute has elapsed.1.
During 2. Review Mode, press SAVE and choose the program slot to be deleted.
Press 3. ENTER.
To Next Page
Loading...
Need help?
General
