Cybex Arc Trainer 750A/750AT Owner’s Manual
68
Recommended Service Schedule
To determine mileage start striding:
During initial countdown, press CLEAR, key in 9-9-9 and pressENTER. The rst menu item is
ODOMETER.
Press ENTER to view accumulated distance.
First 500 Miles (800 KM)
Follow this procedure to ensure the belts are tensioned properly and in good condition.
Remove access cover. (See previous procedure1. Remove Access Cover)
Pull down and roll each belt to examine the condition. If a belt has cracks or appears worn, it must 2.
be replaced immediately by a qualied service technician.
Attach access cover. (See previous procedure3. Attach Access Cover)
Every 5000 Miles (8000 KM)
Check drive belts for tension and wear. (See procedure First 500 Miles)
Move unit and vacuum underneath. Lift the rear of unit and roll it back from its present
position. Vacuum underneath and return unit to normal position.
Clean inside unit.
Remove access cover. (See previous procedure 1. Remove Access Cover)
Using a vacuum cleaner attachment or hand vacuum, clean the exposed components.2.
Remove dirt and debris from internal components.3.
Using a 4. dry cloth, wipe all exposed areas.
Attach access cover. (See procedure5. Attach Access Cover)
Every 20,000 Miles (32000 KM)
Contact qualied service technician to check elevation assembly, replace any worn parts and
lubricate elevation bushings.
To Next Page
Loading...
Need help?
General
