Cybex Arc Trainer 750A/750AT Owner’s Manual
6
Facility Safety Precautions
NOTE: It is the sole responsibility of the user/owner or facility operator to ensure that regular
maintenance is performed.
Enforce all user and safety precautions. •
Read and understand the Owner’s Manual completely before assembling, servicing or using unit.•
Verify all users are properly trained on using the equipment.•
Do not use unit outdoors.•
Verify that each unit is setup, leveled and operated on a solid, level surface. Do not install •
equipment on an uneven surface.
Verify there is enough room for safe access and operation of unit.•
Use Cybex AC power adapters only.•
Do not use the optional power adapter in damp or wet locations.•
Do not use the unit if: (1) the unit is plugged into an optional power adapter that has a damaged •
cord; (2) the unit is not working properly or (3) if the unit has been dropped or damaged. Seek ser-
vice from a qualied technician.
EQUIPMENT is not suitable for use in the presence of aerosol (spray), FLAMMABLE •
ANAESTHETIC MIXTURE WITH AIR or WITH OXYGEN or NITROUS OXIDE.
Perform regular maintenance checks on unit. Performance level can be maintained only if •
examined regularly. Pay close attention to all areas most susceptible to wear, including (but not
limited to) cables, pulleys, belts and grips.
Replace any warning labels if damaged, worn or illegible.•
Immediately replace worn or damaged components. If unable to immediately replace worn or •
damaged components, then remove unit from service until repair is made.
Do not attempt repairs; electrical or mechanical. Seek qualied repair technician when servicing. •
Failure to do so could result in serious injury. Customer Service for contact information.
Use only Cybex supplied components to maintain/repair unit.•
Keep a repair log of all maintenance activities.•
Disconnect the optional power adapter before servicing unit.•
Do not use attachments unless recommended for the unit by Cybex.•
The unit may generate electromagnetic or other forms of interference, or it may be affected by •
interference from other equipment nearby. If this is suspected, take precautions by separating the
equipment or otherwise shielding it to avoid such interference.
To Next Page
Loading...
Need help?
General
