CYBEX Aton2 User Manual

11
d
s
t
c
e
ADJUSTING THE SHOULDER BELTS
NOTE! Only if the shoulder belts c are adjusted correctly
optimum security can be provided.
• When the baby is approximately 3 months the seat
insert can be removed to provide enough space for
the child (see page 27).
• The height of the shoulder belts c must be adjusted
in such a way that they run through the belt slots s
directly above the baby‘s shoulders.
To adjust the height of the shoulder belts c please follow
the next steps:
• Press the red button to open the buckle e.
• Pull the shoulder pads d over the belt tongues t to
remove them.
• First pull one buckle tongue t through the cover and
out of the belt slot s. Now insert it again through the
next higher slot. Repeat this step to adjust the other
side as well.
NOTE! Please make sure that the shoulder belts c are
not twisted but should lie at against the main seat, run
evenly through the belt slots s and down to the buckle e.

CYBEX Aton2 Specifications

General

Category	Infant Car Seat
Height Capacity	Up to 32 inches
Installation Type	LATCH or Vehicle Seat Belt
Base Included	Yes
Side Impact Protection	Yes
Recline Positions	Multiple
Harness Type	5-point harness
Infant Insert	Yes
Safety Standards	FMVSS 213
Stroller Compatibility	Yes, with CYBEX strollers
Additional Features	Linear Side-impact Protection
Weight Capacity	4-35 lbs