CYBEX Aton2 User Manual

19
INSTALLING THE SEAT
• Make sure that the carrying handle a is in the upper
position A. (see page 9)
• Place the seat against driving position on the car
seat. (The feet of the baby point in the direction of the
backrest of the car seat).
• CYBEX ATON 2 can be used on all seats with a
three-point automatic retractor belt. We generally
recommend to use the seat in the back of the
vehicle. In the front, your child is usually exposed to
higher risks in case of an accident.
WARNING! The seat must not be used with a two-
point belt or a lap belt. When securing your child
with a two-point belt, this may result in injuries or
death of the child.
• Make sure that the horizontal marking on the safety
sticker p is parallel to the oor.
• Pull the three-point belt over the child seat.
• Insert the belt tongue into the car belt buckle q.
a
p
a
k
q

CYBEX Aton2 Specifications

General

Category	Infant Car Seat
Height Capacity	Up to 32 inches
Installation Type	LATCH or Vehicle Seat Belt
Base Included	Yes
Side Impact Protection	Yes
Recline Positions	Multiple
Harness Type	5-point harness
Infant Insert	Yes
Safety Standards	FMVSS 213
Stroller Compatibility	Yes, with CYBEX strollers
Additional Features	Linear Side-impact Protection
Weight Capacity	4-35 lbs