CYBEX Aton2 User Manual

27
• that the car buckle q is not reaching all the way to the
blue belt slot m
• that the car belt is tight and not twisted
• that the ATON 2 is vertically installed on the car seat
(see marking)
NOTE! The CYBEX ATON 2 is exclusively made for
forward facing car seats, which are equipped with a
3-point belt system according to ECE R16.
• Lift up the linear-side.impact protection (LSP) device
to improve side protection during a side collision.
REMOVING THE INSERT
The insert, which is preinstalled when purchased, helps
to support lying comfort and t for the smallest babies.
In order to remove the insert please loosen the cover in
the baby seat, lift the insert a little bit and take it out of
the seat.
The insert may be removed after approx. 3 months to
provide more space.
The adjustable insert x (left picture top of page 35)
enhances the comfort of the child up to approx.
9 months. Later the insert can be removed to give the
child additional space.
q
m

CYBEX Aton2 Specifications

General

Category	Infant Car Seat
Height Capacity	Up to 32 inches
Installation Type	LATCH or Vehicle Seat Belt
Base Included	Yes
Side Impact Protection	Yes
Recline Positions	Multiple
Harness Type	5-point harness
Infant Insert	Yes
Safety Standards	FMVSS 213
Stroller Compatibility	Yes, with CYBEX strollers
Additional Features	Linear Side-impact Protection
Weight Capacity	4-35 lbs