CYBEX Aton2 User Manual

23
• Lift up the linear-side.impact protection (LSP) device
to improve side protection during a side collision.
NOTE: It is not allowed to lift up the side protector (LSP)
on the side turned away from the vehicle door.
• Listen for an audible CLICK, when it locks
NOTE: When using the ATON 2 on a middle position in
the vehicle, it’s prohibited to fold out the (LSP) device.
WARNING! Using the (LSP) device to carry or to
fasten the ATON 2 is prohibited.
NOTE! When using ATON 2 in combination with ATON
Base or ATON Base-x the driving-position of the handle
changes from A to B.
REMOVING THE CAR SEAT
By pressing the locking devices f, you can fold the (LSP)
devices downwards into the original position.
NOTE: Before removing the ATON 2 from the vehicle,
fold the (LSP) devices back into place. This protects the
(LSP) device and the vehicle itself from damage.
• Take the seat belt out of the blue belt slot n in the
back.
• Open the car buckle q and take the lap belt k out of
the blue belt slots m.
A
B
LSP
LSP
f
LSP

CYBEX Aton2 Specifications

General

Category	Infant Car Seat
Height Capacity	Up to 32 inches
Installation Type	LATCH or Vehicle Seat Belt
Base Included	Yes
Side Impact Protection	Yes
Recline Positions	Multiple
Harness Type	5-point harness
Infant Insert	Yes
Safety Standards	FMVSS 213
Stroller Compatibility	Yes, with CYBEX strollers
Additional Features	Linear Side-impact Protection
Weight Capacity	4-35 lbs