Cybex 445T Treadmill Owner’s Manual
Assembly
and Setup
Page 2-12
WARNING: Be sure that all electrical requirements are met as indicated in the specifi cations at
the front of the manual and at the beginning of this chapter prior to proceeding.
Testing the Treadmill Operation
Use the following instructions to test the full speed and incline range of the treadmill and to check the
belt for proper operation.
CAUTION: During this procedure STAY OFF THE RUNNING BELT! Stand with your feet on the two
steps.
1. Without anyone on the treadmill, plug the power cord into a power outlet from a grounded,
dedicated circuit as described under Electrical Requirements in this chapter.
2. Locate the on/off (I/O) power switch under the right side rails of the treadmill. Toggle it to the on
position (I).
3. The control panel will light up and be in the Dormant Mode.
NOTE: Cybex recommends that the treadmill be unplugged or the on/off (I/O) power switch turned off
(O) when it is not in use.
4. Press the Quick Start key. The treadmill begins a countdown “3...2...1” and sounds a tone for each
count. After it reaches one (1), the treadmill gives a shorter tone and then begins accelerating the
belt to reach 0.5 mph (0.8 kph).
5. The bottom left display will flash the time and the right display will show the actual speed.
6. Press and hold down the Speed + key until the treadmill reaches a speed of approximately 4 mph
(6.4 kph), as indicated on the display.
7. Observe the belt to see that it is running properly; it should stay centered in the middle of the
deck. If you have problems with the running belt operation, see Running Belt Adjustments in the
Preventive Maintenance chapter.
8. Run the treadmill through its full speed range. First press the Speed + key until the treadmill
reaches its highest speed, 11.0 mph (17.6 kph). Then press the Speed - key until the treadmill is
back to 0.5 mph (0.8 kph).
9. As you press the Incline Λ V or Speed + - keys, the respective displays will show the actual incline
or speed.
10. When the treadmill reaches the set incline and speed, the displays will remain steadily illuminated to
indicate that the desired settings have been reached.
To Next Page
Loading...
Need help?
General
