Cybex 445T Treadmill Owner’s Manual
Preventive
Maintenance
Page 4-2
NOTE: Do not spray cleaning solution directly on the treadmill. Direct spraying could cause damage to
the electronics and may void the warranty.
WARNING: To prevent electrical shock, be sure that power is shut off and the treadmill is
unplugged from the electrical outlet before performing any cleaning or maintenance
procedures.
After Each Use — Wipe up any liquid spills immediately. After each workout, use a cloth to wipe up any
remaining perspiration from the handrails and painted surfaces.
Be careful not to spill or get excessive moisture between the edge of the display panel and the console,
as this might create an electrical hazard or cause failure of the electronics.
As Needed — Vacuum any dust or dirt that might accumulate under or around the treadmill. Motors are
especially susceptible to dust and dirt, and restricted airflow can prevent adequate cooling that could
shorten motor life. Cleaning this area should be done as often as indicated in the Service Schedule.
WARNING: Keep wet items away from inside parts of the treadmill. Electrical shock could occur
even if the treadmill is unplugged. Do not touch components on the lower board.
A charge can remain after unplugging the power cord.
To clean the motor components, you must raise the elevation to 15% elevation. Unplug the treadmill
and carefully lift the rear of the treadmill. Lift the treadmill until it rests on the top of the console. Use
a vacuum attachment or hand vacuum to clean the exposed elevation assembly, drive motor, lower
electronics and the surrounding areas. Wipe clean the underside of the treadmill to prevent dirt and dust
build-up.
Also use a dry cloth for the areas that you can’t reach with the vacuum cleaner. If the machine has not
been used for some time or is excessively dirty, use a dry cloth to wipe all exposed areas.
Carefully lower the rear of the treadmill and roll it back from its present position to vacuum the floor area
underneath the unit. When finished, return the treadmill to its normal position.
Contact Heart Rate Grips — Contaminants, such as hand lotions, oils or body powder, may come off
on the contact heart rate grips. These can reduce sensitivity and interfere with the heart rate signal. It is
recommended that the user have clean hands when using the contact heart rate. Clean the grips using
a cloth dampened with a cleaning solution containing rubbing alcohol. The grips are the only part of the
treadmill you should use a cleaning solution containing rubbing alcohol.
To Next Page
Loading...
Need help?
General
