EasyManua.ls Logo

CycleOps PowerTap SLC+

CycleOps PowerTap SLC+
45 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
COMPUTER BATTERIES
The PowerTap SL2.4 has batteries in the hub and computer. Computer batter-
ies typically need to be changed every 400 hours of use. The computer will
also say “low bat” when the computer battery needs to be changed. This mes-
sage is displayed after a clr is performed. To replace computer battery (Type
CR2032), remove the computer from the mount. Remove the battery cover on
the back of the computer (use a cone wrench to remove the battery cover),
excha
nge the battery, and replace the cover as shown below (FIGURE 29).
TECHNICAL SPECIFICATIONS
Accuracy +/-1.5%
Signal Transmission 2.4 Ghz
Interval Data Storage Unlimited
Interval Display 9 Intervals (internal recording)
Operational Temperature 0 to 40 degrees c or 32 to 104 f
Battery Life (Hub) 300 hours approx.
Battery Life (CPU) 400 hours approx.
Battery Type (Hub) Type 357/303 or EPX 76 (2 ea) - (IEC-SR44)
Battery Type (CPU CR2032
RANGE OF MEASUREMENT
Power 0-1999 Watts
Torque 0-1999 inch-lbs.
Speed 2-59 mph (3-95 KPH)
Distance 0.00 to 9999.99 (Miles)
Trip Time 0.00.00-999.99 Minutes
Cadence 40-240 RPM
Total energy 0-99999 Kilojoules
Odometer 0-99999 Miles or Kilometers
Heart Rate 0-255 BPM (Beats per Min
ute)
37
FIGURE 29

Other manuals for CycleOps PowerTap SLC+

Related product manuals