-Slide the battery pack back into position along the center core. As the pack is engaged a small
increase of resistance to installation should be felt as the electrical connections are made.
- Thread the cap all the way back on.
- Replacement O-rings and battery packs are available from Saris Cycling Group.
TEST MODE
1) From the computer setup main menu press [SELECT] and scroll until the letter “t” is flashing.
Press [MODE] to enter test mode setup.
2) Press [MODE] to scroll through the different test modes as shown by the number. NOTE: Press
and hold [MODE] and [SELECT] simultaneously returns to standard operation.
0 - Model and version.
Displays the computer model on the middle line and firmware version number on the bottom
line.
1 - LCD Test
Displays all the LCD segments. Press [SELECT] to return to the normal screen.
2 - Heart Rate Sign
al Test
NOTE: The heart rate signal is illuminated.
The middle line display flashes “88” with each heart rate blip received.
3- Torque Information
NOTE: The T icon is displayed.
This displays information about the internal workings of the torque readings. The bottom display
is the offset torque value directly sent by the hub torque with no correction applied. The hub
sends a value of approximately 512 as the zero point. The middle line display is the
correction
offset value currently stored in the computer. This is the value that is changed when you do a
manual zeroing of the torque. The top display is the corrected actual torque (the bottom value
minus the middle value).
39
To Next Page
Loading...
Need help?
General
