50
Cypress Confidential
Programming Repeater Network ID
Press and release all three buttons
simultaneously to enter programming mode.
Network ID Programming Mode
1. Press and release all three buttons simultaneously
2. Using the top and bottom buttons, enter the Network ID that you wrote down from
the WPT web console
NOTE: Network ID can never be “0”.
3. Press center button to confirm.
NOTES:
1. The Repeater is factory configured with Network ID 1. You can leave the Network ID unchanged
by pressing the center button.
2. The Repeater will exit programming mode automatically if there is no action for 1 minute
To Next Page
Loading...
