What to do if my Cyrus ONE HD has no sound?
If your Cyrus Amplifier is producing no sound, first ensure that the mute function is off. Also, verify that the audio source is properly functioning, for example, check if the CD is playing and not paused.
What to do if my Cyrus Amplifier shows an Output error?
If your Cyrus Amplifier shows an Output error, it might be due to a short-circuit at the loudspeaker terminals. The amplifier will mute until it cools down. Try improving ventilation around the amplifier. If the problem persists, the impedance of your speakers may be too low. Switch off the amplifier and check for short circuits in the speaker wiring.
Why is there no sound from one loudspeaker connected to my Cyrus Amplifier?
If there's no sound coming from one loudspeaker connected to your Cyrus Amplifier, the BAL control might be at its extreme limit. Centralize the balance. Also, check if your speaker has fuses and replace them if necessary. Inspect the speaker cables and interconnects for faults; check connections and replace cables if needed.
What does PSU error mean on my Cyrus ONE HD?
If your Cyrus Amplifier displays a PSU error, this could be a temporary issue from playing excessive deep bass or a fault in the power supply. The amplifier will mute when the error is detected. If the error clears, it will continue to play normally. If the error persists, return the amplifier to your retailer.
Why is there hum when playing vinyl on my Cyrus ONE HD Amplifier?
If you experience hum when playing vinyl on your Cyrus Amplifier, there may be a turntable grounding problem. Check that the turntable ground wire is securely connected to the grounding terminal on the back panel and that the pickup cartridge is correctly connected.
How to fix a Bluetooth source that fails to pair with my Cyrus ONE HD Amplifier?
If a Bluetooth source fails to pair with your Cyrus Amplifier, ensure that Bluetooth connectivity is enabled on the source device. If the problem continues, switch the amplifier off and on, then try pairing again.
Why is my Cyrus ONE HD producing spurious noises from speakers?
If your Cyrus Amplifier is producing spurious noises from the speakers, the interconnects or connections may be faulty. Check and replace them where necessary.
Why is the volume low when playing vinyl on my Cyrus ONE HD Amplifier?
If you are experiencing low volume when playing vinyl on your Cyrus Amplifier, ensure that the pickup cartridge is a Moving Magnet type and not a Moving Coil.
What to do if my Cyrus Amplifier shows over-temperature error?
If your Cyrus Amplifier is showing an over-temperature error, check that the ventilation slots on the amplifier are not obstructed.
What to check if there is no sound from a digital audio source on my Cyrus Amplifier?
If you have no sound from a digital audio source connected to your Cyrus Amplifier, check that the source is connected correctly and set to play. Ensure that the correct input is selected and that the digital sample rate is compatible with the Cyrus ONE HD.
Details power requirements, servicing procedures, and contact for service.
Information on trademarks, regulatory compliance, and disclaimers.
Guidance for amplifier installation and rear panel overview.
Important notes on connecting sources, including turntable, analogue, and digital audio.
Identifies and explains the front panel buttons and indicators.
Instructions for switching the amplifier on and off using the power button.
Steps for pairing devices and playing music wirelessly via Bluetooth.
How to play audio from turntable, analogue, digital, and USB sources.
Adjusting volume and using the headphone output for private listening.
Guide on installing and using the mobile app for amplifier control.
Details on app features like volume limiter, channel balance, and AV Direct mode.
Explanation of AV Direct mode, home cinema connection, and factory reset.
Common problems, diagnostic indicators, and solutions for amplifier issues.
Detailed technical data, including power, audio performance, and connectivity.
Information on product warranty terms and WEEE disposal instructions.
General| Type | Integrated Amplifier |
|---|---|
| Inputs | 1 x Optical, 1 x Coaxial, Bluetooth |
| Outputs | Speaker terminals, Pre-out |
| Bluetooth | Yes |
| Dimensions | 85 x 220 x 390 mm (H x W x D) |
| Power Output | 2 x 100W (6 Ω) |
To Next Page
