Cyrus Power Amplifier TROUBLE SHOOTING
17
English
The Standby light flashing YELLOW
• This indicates that there is a DC voltage at the output
of the Cyrus Power. In this case disconnect all inputs
and outputs and switch on again. If the problem does
not clear, return the Cyrus Power to your Mission
distributor for checking.
The Standby light flashing RED/GREEN
• This indicates that the RCA/XLR switch has been
changed whilst the amplifier is operating. Return the
switch to it's original position or if the other input is
required set the Cyrus Power to Standby before
operating the switch.
The MBLOC light flashing RED
• This indicates that the STEREO/MBLOC switch has
been changed whilst the amplifier is operating.
Return the switch to it's original position.
The MUTE light glowing red
•
••
• This is a normal condition for six seconds after the
Standby light changes to green or should any of the
above faults be detected. MUTE indication at any
other time indicates a possible fault condition. In this
case, return the Cyrus Power to your Mission
distributor for checking.
To Next Page
Loading...
