Cyrus Power Amplifier CAUTIONS
3
English
Your Cyrus Power is factory set to operate from a fixed
mains supply voltage, which is marked on a label at the
rear of the unit. Before connecting, check that this voltage
is the same as your mains supply, i.e.
230V Products Voltage Range 220V-240V
115V Products Voltage Range 110V-120V
UNPACKING
Always follow the instruction handbook and retain it in a
safe place for future reference.
Before proceeding with installing the Cyrus Power, ensure
that the following items are included in the accessory box:
• Instruction Manual with Guarantee Card
• Power Cable
• 4 Loudspeaker Plugs
After removing these items, please retain the packing for
future use.
LOCATION
Install the amplifier in a well ventilated location where it
will not be exposed to high temperature or humidity.
Avoid installing the Cyrus Power in a location which is
exposed to direct rays of the sun, or near to hot appliances
or radiators. Placing and using the amplifier for long
periods on heat-generating sources will affect
performance and may damage the cabinet. Installation in a
damp or dusty environment may result in a malfunction or
an accident.
RE-LOCATION
The Cyrus Power is supplied ready for use in your
location. Care has been taken to ensure that the power
supply requirements are correctly set. Consult your
Mission distributor to arrange for conversion of your
Cyrus Power should you move to another area with a
different mains voltage supply.
PRECAUTIONS REGARDING INSTALLATION
It is important not to allow any liquid or foreign object fall
into this unit. When routing the power cord avoid running
it over or near sharp objects.
If the amplifier is not to be used for a long period of time,
unplug the unit from the mains power supply.
This unit contains no user serviceable parts, therefore
never
remove any panels from the unit or attempt to
service the unit. In the unlikely event of failure, please
refer to qualified service personnel.
To Next Page
Loading...
