Cyrus Power - Installation; Unit Setup and Power Connection

Cyrus Power Amplifier INSTALLATION
5
English
POSITIONING THE UNIT
The Cyrus Power may be positioned as a free standing
unit or alongside another piece of audio equipment. Never
stand the Cyrus Power under another unit. This may
adversely affect the efficient cooling of the Cyrus Power.
Never place the Cyrus Power on a carpet or similar
material which may hamper normal ventilation.
CONNECTING THE UNIT
The Mains Supply
The moulded IEC connector of the mains lead supplied
should be plugged in to the power inlet
13
on the rear of
the unit.
The mains fuse
12
is located on the rear panel next to the
power switch. It must only be replaced with the following
types:
U.K. / Europe - 230V T1A/20mm
N. America / Far East - 115V T2A/20mm
In the U.K., the Cyrus Power comes with the mains plug
fitted. In the unlikely event that the plug fuse should need
replacing ensure that it is only replaced with a 3 Amp
Fuse.
IMPORTANT
NOTE TO USERS OF PSX-R WITH Cyrus Power
In order to use a PSX-R regulated power supply with the
Cyrus Power, certain internal adjustments must be made
to the Cyrus Power which can only be carried out by an
authorised Mission distributor or his agent. Connection
of the PSX-R to a Cyrus Power which is not correctly
adjusted will result in fault condition display on the
Cyrus Power. The Cyrus Power fault indication system
is fully described in the Cyrus Power handbook.
Connecting a
PSX-R
Power Supply (Optional)
If a PSX-R is to be used with the Cyrus Power, proceed to
connect the umbilical cord of the PSX-R to the 5-pin
Cannon input socket of the Cyrus Power. When correctly
fitted, the connector will latch into place in the socket.
Note that when a PSX-R is in use, both the PSX-R power
supply and the Cyrus Power will require mains power.
Note:
For more details on the PSX-R, please refer to the Cyrus
PSX-R Instruction Manual.