Cyrus Power - Page 8

Cyrus Power Amplifier INSTALLATION
7
English
colour coding of the plugs to keep left and right channels
correctly ordered.
Input Connection to the
Cyrus Power
using Balanced
XLR cables
Set the STEREO/MBLOC selector switch
3
to Stereo
and set the input selector switch
6
to BAL. Connect two
Balanced XLR interconnects, one each from left and right
Balanced outputs of the preamplifier to the Cyrus Power's
BAL inputs
7
.
Ensure that left and right channels are
identified and connected at each end.
Connecting Loudspeakers for stereo operation
The left and right loudspeakers are connected to the rear
panel sockets
9
and
2
of the Cyrus Power respectively
using the plugs provided. First, fit the plugs to the
loudspeaker cables. Carefully note that the cable carries
marking or colours for polarity (+ and -) and may also be
marked for direction with an arrow. For correct operation,
it is essential that the (+ and - ) terminals of the amplifier
are connected to the corresponding (+ and -)
terminals of the loudspeakers. When fitting the plugs to
the cables be sure to line up (+ and -) at each end using the
red plug for the '+' and the black plug for the '-'. The
loudspeaker plugs can now be plugged into the amplifier
sockets.
Rear view of a typical Cyrus Pre &
Cyrus Power stereo system. Connect
either the RCA phono (black) or XLR
Balanced input connections (dark grey),
but never both together. Bi-wired
speaker connections are also shown
(light grey).