D-Link AirPremier N DAP-2310

46D-Link DAP-2310 User Manual
Section 3 - Conguration
AP Array
An AP array is a set of devices on a network that are organized into a single group to increase ease of management.
This check box allows the user to enable the AP
array function. The three modes that are available
are Master, Backup Master, and Slave. APs in the
same array will use the same conguration. The
conguration will sync the Master AP to the Slave
AP and the Backup Master AP when a Slave AP
and a Backup Master AP join the AP array.
Enter a name for the AP array you have created.
Enter a password that will be used to access the
AP array you have created.
Click this button to initiate a scan of all the
available APs currently on the network.
This table displays the current AP array status for
the following parameters: Array Name, Master
IP, MAC, Master, Backup Master, Slave, and Total.
This table displays all the current array members.
The DAP-2310 AP array feature supports up to
eight AP array members.
Enable Array:
AP Array Name:
AP Array
Password:
Scan AP Array
List:
AP Array List:
Current Array
Members: