48D-Link DAP-2553 User Manual
Section 3 - Configuration
Static Pool Setting
The DHCP address pool defines the range of IP addresses that can be assigned to stations on the network. A static
pool allows specific wireless stations to receive a fixed IP without time control.
Dynamic Host Configuration Protocol (DHCP)
assigns IP addresses to wireless devices on
the network. This protocol simplifies network
management and allows new wireless devices
to receive IP addresses automatically without
the need to manually assign IP addresses.
Select Enable to allow the DAP-2553 to
function as a DHCP server.
Use the Static Pool Settings to assign the
same IP address to a device every time you
start up. The IP addresses assigned in the
Static Pool list must NOT be in the same IP
range as the Dynamic Pool. After you have
assigned a static IP address to a device via
its MAC address, click Save; the device will
appear in the Assigned Static Pool at the
bottom of the screen. You can edit or delete
the device in this list.
Enter the MAC address of the device
requesting association here.
Define the submask of the IP address specified in the “IP Assigned From” field.
Function Enable/
Disable:
Assigned IP:
Assigned MAC
Address:
Subnet Mask:
To Next Page
Loading...
