DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
157
config radius add
<server_ip> The IP address of the RADIUS server.
key Specifies that a password and encryption key will be used between
the Switch and the RADIUS server.
<passwd 32> The shared-secret key used by the RADIUS server and
the Switch. Up to 32 characters can be used.
default Uses the default UDP port number in both the “auth_port” and
“acct_port” settings.
auth_port <udp_port_number 1-65535> The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535> The UDP port number for
accounting requests. The default is 1813.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure the RADIUS server communication settings:
DES-3028P:4#config radius add 1 10.48.74.121 key dlink
default
Command: config radius add 1 10.48.74.121 key dlink
default
Success.
DES-3028P:4#
config radius delete
Purpose Used to delete a previously entered RADIUS server configuration.
Syntax
config radius delete <server_index 1-3>
Description The config radius delete command is used to delete a previously
entered RADIUS server configuration.
Parameters
<server_index 1-3> Assigns a number to the current set of
RADIUS server settings. Up to 3 groups of RADIUS server settings
can be entered on the Switch.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To delete previously configured RADIUS server communication settings:
DES-3028P:4#config radius delete 1
Command: config radius delete 1
Success.
DES-3028P:4#
config radius
Purpose Used to configure the Switch’s RADIUS settings.
Syntax
config radius <server_index 1-3> {ipaddress <server_ip> | key
<passwd 32> | auth_port <udp_port_number 1-65535> |
To Next Page
Loading...
