D-Link DES-3052P - Page 163

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
158
config radius
acct_port <udp_port_number 1-65535>}
Description The config radius command is used to configure the Switch’s
RADIUS settings.
Parameters
<server_index 1-3>  Assigns a number to the current set of
RADIUS server settings. Up to 3 groups of RADIUS server settings
can be entered on the Switch.
ipaddress <server_ip>  The IP address of the RADIUS server.
key  Specifies that a password and encryption key will be used
between the Switch and the RADIUS server.
 <passwd 32>  The shared-secret key used by the RADIUS
server and the Switch. Up to 32 characters can be used.
auth_port <udp_port_number 1-65535>  The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535>  The UDP port number for
accounting requests. The default is 1813.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure the RADIUS settings:
DES-3028P:4#config radius 1 10
.
48.74.121 key dlink
default
Command: config radius 1 10.48.74.121 key dlink
default
Success.
DES-3028P:4#
config radius parameter
Purpose Used to configure parameters for radius servers.
Syntax
config radius parameter { timeout <int 1-255> | retransmit <int 1-
255>}
Description Used to configure parameters for radius servers.
Parameters
timeout <int 1-255>  The time in second for waiting server reply.
Default value is 5 seconds.
retransmit <int 1-255>  The count for re-transmit.
Default value is 2.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure the timeout option for radius servers.
DES-3028P:4# config radius parameter timeout 3
Command: config radius parameter timeout 3
Success.
DES-3028P:4#