DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
159
show radius
Purpose Used to display the current RADIUS configurations on the Switch.
Syntax
show radius
Description The show radius command is used to display the current RADIUS
configurations on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display RADIUS settings on the Switch:
DES-3028P:4#show radius
Command: show radius
Timeout : 5 seconds
Retransmit : 2
Index IP Address Auth-Port Acct-Port Status Key
Number Number
----- ------------------ --------- --------- -------------- ---------------
1 10.1.1.1 1812 1813 Active switch
2 20.1.1.1 1800 1813 Active des3226
3 30.1.1.1 1812 1813 Active dlink
Total Entries : 3
DES-3028P:4#
create 802.1x guest_vlan
Purpose Used to configure a pre-existing VLAN as a 802.1X Guest VLAN.
Syntax
create 802.1x guest_vlan <vlan_name 32>
Description The create 802.1x guest_vlan command is used to configure a pre-
defined VLAN as a 802.1X Guest VLAN. Guest 802.1X VLAN clients
are those who have not been authorized for 802.1X or they haven’t
yet installed the necessary 802.1X software, yet would still like to
have limited access rights on the Switch.
Parameters
<vlan_name 32> Enter an alphanumeric string of no more than 32
characters to define a pre-existing VLAN as a 802.1X Guest VLAN.
This VLAN must have first been created with the create vlan
command mentioned earlier in this manual.
Restrictions Only Administrator-level users can issue this command.
Users must have already previously created a VLAN using the
create vlan command. Only one VLAN can be set as the 802.1X
Guest VLAN.
Example usage:
To configure a previously created VLAN as an 802.1X Guest VLAN for the Switch:
To Next Page
Loading...
