D-Link DES-3052P - Page 328

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
323
DES-3028P:4#d
i
sable address
_
binding
trap_log
Command: disable address_binding trap_log
Success.
DES-3028P:4#
show address_binding dhcp_snoop
Purpose To show address_binding entries created by DHCP packet.
Syntax
show address_binding dhcp_snoop {[max_entry {ports
<portlist>} | binding_entry {port <port>}]}
Description This command is used to show address_binding dhcp_snoop
information.
Parameters <portlist> – Specifies a port or range of ports.
<ports> – Specifies ports on the device.
Restrictions None.
Example usage:
To show address_binding dhcp_snoop:
DES-3028P:4# show address_binding dhcp_snoop
Command: show address_binding dhcp_snoop
DHCP_Snoop : Enabled
Success.
DES-3028P:4#
To show address_binding dhcp_snoop entry:
DES-3028P:4# show address_binding dhcp_snoop binding_entry
Command: show address_binding dhcp_snoop binding_entry
IP Address MAC Address Lease Time (secs) Port Status
----------- ----------------- ----------------- ---- ------
10.1.1.1 00-00-00-00-00-11 1188 1 Active
Total entries : 1
DES-3028P:4#
To show address_binding dhcp_snoop max_entry: