Need help?Do you have a question about the D-Link DFE-530TX and is the answer not in the manual?
General| Interface | PCI |
|---|---|
| Standards | IEEE 802.3, IEEE 802.3u |
| Data Transfer Rate | 10/100 Mbps |
| Connector | RJ-45 |
| Device Type | Network adapter |
| Form Factor | Plug-in card |
| Data Link Protocol | Ethernet, Fast Ethernet |
| Cable Type | 10Base-T, 100Base-TX |
| Full Duplex Support | Yes |
| LED Indicators | Link/Activity |
| Operating System Support | Windows, Linux |
| Ports | 1 x RJ45 |
Explains Advanced Configuration and Power Interface for power saving.
Describes the feature to power on computers remotely.
Details IEEE 802.3x flow control for full duplex operation.
Lists key features and capabilities of the DFE-530TX adapter.
Instructions for unpacking and verifying contents of the adapter package.
Step-by-step guide for physically installing the adapter card into a PCI slot.
Procedure for connecting the Wake-On-LAN cable to the NIC and motherboard.
How to connect the adapter for 100Mbps Fast Ethernet using Category 5 UTP cable.
How to connect the adapter for 10Mbps Ethernet using Category 3, 4, or 5 UTP cable.
Guidance on installing the adapter's software drivers.
General steps to diagnose and resolve adapter issues.
Explains the meaning of the adapter's LINK/ACT, 100M, and FULL LEDs.
Details the network standards (100Base-TX, 10Base-T) and media interface.
Lists physical dimensions, host interface, and EMI compatibility.
Outlines storage and operating temperature and humidity ranges.
Lists supported operating systems and network protocols for driver installation.
Provides contact details for D-Link offices worldwide for support and service.
Form for registering the product, including purchase and usage information.
To Next Page
