D-Link DFL-260E

List of Examples
1. Example Notation .............................................................................................15
2.1. Enabling remote management via HTTPS ...........................................................35
2.2. Enabling SSH Remote Access ..........................................................................41
2.3. Listing Configuration Objects ...........................................................................53
2.4. Displaying a Configuration Object .....................................................................54
2.5. Editing a Configuration Object .........................................................................55
2.6. Adding a Configuration Object .........................................................................55
2.7. Deleting a Configuration Object ........................................................................56
2.8. Undeleting a Configuration Object ....................................................................56
2.9. Listing Modified Configuration Objects ..............................................................57
2.10. Activating and Committing a Configuration .......................................................57
2.11. Enable Logging to a Syslog Host .....................................................................61
2.12. Sending SNMP Traps to an SNMP Trap Receiver ...............................................63
2.13. RADIUS Accounting Server Setup ..................................................................70
2.14. Enabling SNMP Monitoring ...........................................................................74
2.15. Performing a Complete System Backup ............................................................85
2.16. Complete Hardware Reset to Factory Defaults ...................................................85
3.1. Adding an IP Host Address ..............................................................................89
3.2. Adding an IP Network .....................................................................................89
3.3. Adding an IP Range ........................................................................................90
3.4. Deleting an Address Object ..............................................................................90
3.5. Adding an Ethernet Address .............................................................................91
3.6. Adding IPv6 Host Addresses ............................................................................93
3.7. Enabling IPv6 Globally ...................................................................................94
3.8. Enabling IPv6 on an Interface ...........................................................................94
3.9. Enabling IPv6 Advertisements ..........................................................................95
3.10. Listing the Available Services .........................................................................98
3.11. Viewing a Specific Service .............................................................................99
3.12. Creating a Custom TCP/UDP Service ............................................................. 102
3.13. Adding an IP Protocol Service ...................................................................... 104
3.14. Defining a VLAN ....................................................................................... 117
3.15. Configuring a PPPoE Client ......................................................................... 120
3.16. Creating an Interface Group .......................................................................... 124
3.17. Displaying the ARP Cache ........................................................................... 127
3.18. Flushing the ARP Cache ..............................................................................127
3.19. Defining a Static ARP Entry ......................................................................... 128
3.20. Adding an Allow IP Rule ..............................................................................141
3.21. Setting up a Time-Scheduled Security Policy ................................................... 147
3.22. Uploading a Certificate ................................................................................150
3.23. Associating Certificates with IPsec Tunnels ..................................................... 151
3.24. Setting the Current Date and Time ................................................................. 153
3.25. Setting the Time Zone ................................................................................. 154
3.26. Enabling DST ............................................................................................ 154
3.27. Enabling Time Synchronization using SNTP ....................................................155
3.28. Manually Triggering a Time Synchronization ..................................................156
3.29. Modifying the Maximum Adjustment Value ....................................................156
3.30. Forcing Time Synchronization ......................................................................157
3.31. Enabling the D-Link NTP Server ................................................................... 157
3.32. Configuring DNS Servers ............................................................................. 160
4.1. Displaying the main Routing Table .................................................................. 171
4.2. Adding a Route to the main Table ................................................................... 172
4.3. Displaying the Core Routes ............................................................................173
4.4. Creating a Routing Table ...............................................................................184
4.5. Adding Routes ............................................................................................. 184
4.6. Creating a Routing Rule ................................................................................185
4.7. Policy-based Routing with Multiple ISPs .......................................................... 188
4.8. Setting Up RLB ...........................................................................................194
4.9. Creating an OSPF Router Process ................................................................... 217
12