IPv6 and High Availability
NetDefendOS High Availability (HA) does not fully support IPv6. Any IPv6 configuration objects
will be mirrored on both the HA master and slave units. However, if a failover occurs, state
information will be lost when one unit takes over processing from the other and IPv6 connections
will be lost.
In an HA configuration where interfaces have IPv6 enabled and IPv6 addresses assigned, there is no
private and shared IPv6 IP for each pair of interfaces. Each interface pair will have the same IPv6 IP
address on both master and slave. A private IPv6 interface address for each interface in a pair is not
possible.
3.2. IPv6 Support Chapter 3. Fundamentals
97
To Next Page
Loading...
