D-Link DGS-1210-10/ME - L3 Functions > Ipv4 Routing Table Finder; L3 Functions > Ipv6 Static Route

4 Configuration DGS-1210 series Metro Ethernet Managed Switch User Manual
1
1
4
4
7
7
Figure 4.229 – L3 Functions > IPv4 Static Route
IPv4 Address: Specifies an IPv4 address to be assigned to the static route.
Netmask: Specifies a subnet mask to be applied to the corresponding subnet mask of the IPv4 address.
Gateway: Specifies the entry of a Gateway IP address to be applied to the corresponding gateway of the
IPv4 address.
Metric (1-65535): Represents the metric value of the IP interface entered into the table. The value ranges
between 1 and 65535.
Backup State: Each IP address can only have one primary route, while other routes should be assigned to
the backup state. When the primary route failed, Switch will try the backup routes according to the order
learnt by the routing table until route success. The field represents the Backup state that the Static and
Default Route is configured for.
Click Add to create a new IPv4 static route entry.
L3 Functions > IPv4 Routing Table Finder
The IPv4 routing table stores all the external routes information of the Switch. The IPv4 Routing Table
Finder page displays all the routing information on the Switch.
Figure 4.230 – L3 Functions > IPv4 Routing Table Finder
Network Address; Specifies the destination network address of the route to be displayed.
Click Search to display the information of specified route entry.
L3 Functions > IPv6 Static Route
A static entry of an IPv6 address can be entered into the Switch’s routing table for IPv6 formatted addresses.