D-Link DGS-1210-10/ME - System > System Log Configuration > System Log Server; System > Time Profile

4 Configuration DGS-1210 series Metro Ethernet Managed Switch User Manual
3
3
9
9
System > System Log Configuration > System Log Server
The user can send Syslog messages to up to four designated servers using the System Log Server. It
supports maximum 500 system log entries. To set the System Log Server configuration, click Apply.
Figure 4.45 - System > System Log Configuration > System Log Server
Server ID: Specifies the Server ID. The field range is 1-4.
Severity: Specifies the minimum severity from which warning messages are sent to the server. There are
three levels. When a severity level is selected, all severity level choices above the selection are selected
automatically. The possible levels are:
Warning - The lowest level of a device warning. The device is functioning, but an operational
problem has occurred.
Informational - Provides device information.
All - Displays all levels of system logs.
Server IPv4 Address: Specifies the IPv4 address of the system log server.
Server IPv6 Address: Specifies the IPv6 address of the system log server.
Facility: Specifies an application from which system logs are sent to the remote server. Only one facility can
be assigned to a single server. If a second facility level is assigned, the first facility is overwritten. There are
up to eight facilities can be assigned (Local 0 ~ Local 7).
UDP Port: Specifies the UDP port to which the server logs are sent. The possible range is 6000 – 65535,
and the default value is 514.
Status: Specifies the status is enable or disable.
System > Time Profile
The Time Profile page allows users to configure the time profile settings of the device.
Figure 4.46 – System > Time Profile Settings
Range Name: Specifies the profile name for the time profile to be configured.
Date: Select Date and specifies the From Day and To Day of the time profile.
Hours (HH MM): Specifies the Start Time and End Time.
Weekdays: Specifies the work day for the time profile. Or tick Select All Days to select all days for the time
profile.
Click Apply to create a new time profile or click Delete to delete a time profile from the table.