29
2. The priority of Gigabit Fiber port is higher than
Copper.
To change the port setting, click on the ID parameter to enter to the
selected port to configure its Speed/Disable and Flow control setting.
Figure 18.
Speed/Disable:
This setting has six modes—100M Full, 100M Half, 10M Full, 10M
Half, Auto and Disable—for speed or port disable selections.
Flow Control:
This setting determines whether or not the Switch will be handling
flow control. Set FlowCtrl to Enable for avoiding data transfer
overflow. Or it sets to Disable; there is either no flow control or other
hardware/software management.
When the port is set to forced mode, then the flow control will
automatically set to Disable.
Default Priority:
To Next Page
Loading...
Need help?
General