32
System > Trap Setting
A Trap Setting allows the Web-Smart Switch to monitor Trap
information through the Web-based Utility of an IP address on the
LAN. By default, Trap Setting is Disabled. When the Trap Setting is
Enabled, enter the Destination IP address of the managing PC that
will receive trap information.
Figure 24 – System > Trap Setting
System Event: Monitors the system’s trapping information.
Device Bootup: Traps system boot-up information.
Illegal Login: Traps events of incorrect password logins,
recording the IP of the originating PC.
Fiber Port Events: Monitors the fiber port status.
Link Up/Link Down: Traps fiber connection information.
Twisted pair Port Events: Monitors the copper cable port status.
To Next Page
Loading...
