DGS-3130 Series Layer 3 Stackable Managed Switch Hardware Installation Guide
66
Redundant Power Supply (RPS) Cable
When connecting the Switch to a Redundant Power Supply, an RPS cable is necessary. Please review this product
for matching cable pins. The following diagram and table show the standard RPS connector and its pin assignments.
Figure B-3 RPS Cable for DPS-500A (14-pin Power Cable)
RPS Cable – 14 PIN Assignments:
Pin Device DPS-500A
1 Not Connected GND
2 GND N/C
3 GND +12V
4 GND +12V
5 GND +12V
6 +12V +12V
7 +12V GND
8 +12V N/C
9 Not Connected N/C
10 Not Connected RPS Power
11 RPS_Present N/C
12 RPS_Power Good N/C
13 Not Connected PWR-Good
14 +12V GND
RPS Cable – 22 PIN Assignments:
To Next Page
Loading...
