D-Link DHP-1320 - Page 124

119D-Link DHP-1320 User Manual
Section 3 - Conguration
Use MAC (Media Access Control) Filters to authorize wireless clients to access your network by their MAC addresses. When enabled, any client not
on the MAC lter list will not be able to access your network.
MAC Address
Filter:
MAC Address:
Wireless Client List:
Save Settings:
Select Enable or Disable from the drop-down
menu.
Enter the MAC address you would like to lter.
To nd the MAC address on a computer, please refer
to the Networking Basics section in this manual. Click
Save Settings to activate and save.
Note: Make sure to enter the computer you are
currently using to congure the access point rst or
you will not be able to access the conguration utility
once you click Save Settings.
Select a DHCP client from the drop-down menu and
click to copy the MAC Address.
Click Save Settings to save and activate the
new changes.
Network Filter