D-Link DHP-1320 - Page 51

46D-Link DHP-1320 User Manual
Section 3 - Conguration
Network
Name:
Public
Network
Name:
Private
Network
Name:
Scan:
Add
Memeber:
Device Name:
Password:
You can set the name of your network and to make it
either public or private. Make sure the Network Name of
all of the devices within your PowerLine network is the
same.
Select this option if you would like to make your powerline
network public with the default Network Name of
“HomePlugAV”. Since this is a commonly used Network
Name, it is less secure than a private Network Name.
Select this option if you wish to make your powerline
network more secure by using a private Network Name.
Type the name of your private PowerLine network in the
eld.
Scan for new PowerLine devices.
This section lets you add new PowerLine AV devices to
your PowerLine network. To add a new device, give it a
Device Name and enter its Password, then click Add. When
you add a device it is given the current Network Name.
Type a name you wish to use to identify a specific
PowerLine AV device. For example, “Jack’s room”.
The Password is used to verify that you are authorized to
perform changes on a device. You can
nd the Password printed on the back of your device.