D-Link DIR-280 - Port Forwarding

28D-Link DIR-280 User Manual
Section 3 - Conguration
Port Forwarding
This will allow you to open a single port or a range of ports.
Check the box to enabled the rule.
Enter a name for the rule.
Enter the IP address of the computer on your local
network that you want to allow the incoming service
to.
Enter the port or ports that you want to open. If you
want to open one port, enter the same port in both
boxes.
Select TCP, UDP, or Any
Rule:
Name:
IP Address:
Start Port/
End Port:
Trafc Type: