D-Link DIR-280 - Advanced Wireless Settings

32D-Link DIR-280 User Manual
Section 3 - Conguration
Set the transmit power of the antennas.
Beacons are packets sent by an Access Point to
synchronize a wireless network. Specify a value. 100
is the default setting and is recommended.
This value should remain at its default setting of
2346. If inconsistent data ow is a problem, only a
minor modication should be made.
The fragmentation threshold, which is specied
in bytes, determines whether packets will be
fragmented. Packets exceeding the 2346 byte setting
will be fragmented before transmission. 2346 is the
default setting.
Transmit Power:
Beacon
interval:
RTS Threshold:
Fragmentation:
DTIM Interval:
Preamble Type:
802.11g Only
Mode::
Advanced Wireless
This window allows you to change the behavior of the 802.11g wireless radio from the standard settings. Please be aware that any
changes to the factory default settings may adversely affect the behavior of your network.
(Delivery Trafc Indication Message) 1 is the default setting. A DTIM is a countdown informing clients of the next window for listening
to broadcast and multicast messages.
Select Short or Long Preamble. The Preamble denes the length of the CRC block (Cyclic Redundancy Check is a common technique
for detecting data transmission errors) for communication between the wireless router and the roaming wireless network adapters. Auto
is the default setting. Note: High network trafc areas should use the shorter preamble type.
Tick this checkbox to restrict access to 802.11g devices only.