DIR-300 Wireless N 150 Home Router
User Manual
Configuring via Web-based Interface
To activate the WPS function, select the WPS Enable checkbox and click the Change button.
When the checkbox is selected, the Information and Connection sections are available on the
page.
Parameter Description
Default PIN code
The PIN code of the router. This parameter is used when connecting
the router to a registrar to set the parameters of the WPS function.
WPS Status
The state of the WPS function:
• Configured (all needed settings are specified)
• Unconfigured (you need to specify the relevant settings).
SSID
The name of the router's WLAN.
Network Authentication The network authentication type specified for the WLAN.
Encryption
The encryption type specified for the WLAN.
Encryption key The encryption key specified for the WLAN.
Refresh
Click the button to refresh the data on the page.
Reset to unconfigured Click the button to reset the parameters of the WPS function.
WPS Method
A method of the WPS function. Select a value from the drop-down
list.
PIN: Connecting the device via the PIN code.
PBC: Connecting the device via the push button (actual or virtual).
PIN Code
The PIN code of the WPS-enabled device that needs to be connected
to the wireless network of the router.
The field is displayed only when the PIN value is selected from the
WPS Method drop-down list.
Connect
Click the button to connect the wireless device to the router's WLAN
via the WPS function.
Page 120 of 170
To Next Page
Loading...
